PPA 210, Portable PA System
Portable Sound System including: 2x 10-inch portable speakers, 1x Powered Mixer, 1x Dynamic Microphone & all component cables needed
Portable Sound System,
8-Channel powered mixer,
3-band EQ, EFX Sound, Pan and Level on each channel,
Built-in 300W (150W 8 ohms per channel) stereo power amplifier with dynamic Distortion Processor
4x XLR MIC inputs.
2x TRS stereo Channels with RCA 3.5mm Stereo inputs.
USB port to connect a flash disc containing music or a MP3 Player,
Effects send on every channel with stereo return,
Internal digital delay effects processor with 16 selections with foot switch jack: including echo, delay and vocal enhancement,
Effects parameter adjustment allows you to customize each effect selection,
7-band system equalizer with switch,
2x five-segment LED meters,
Performance Indicators: Signal, Clip, Power & Protect,
Built-in 300W (150W 8 ohms per channel) stereo power amplifier with dynamic Distortion Processor,
Thermal cut off,
Speaker system with I-inch compression drivers and 10-inch woofers,
Storege compartment for microphone, cables and accessories.
Two 20-foot speaker cables,
Switchable voltage: 115V/60Hz or 230V/50Hz - IEC plug.
Frequency Response: 20 Hz to 20 kHz 1dB (at send output),
30 Hz to 20 kHz 1dB (at speaker output, with processor threshold exceeded),
Distortion: <0.05%, 20 Hz to 20 kHz, 1 dB below rated output,
System Signal-to-Noise Ratio: >80dB @ 1w. "A" WTD,
Power Output 150W per ch. continuous average power: 8 ohm, both channels driven with THD <1%,
Input Impedance (Channels 1-2-3 and 4) "Mic" 2k ohm.